There is a drive board in Hirundo's 1xN MEMS switch module This Driver Board provides the necessary drive circuitry for the 2D MEMS Chip, allowing the user to control four analog voltages between 0 and 60V that actuate the MEMS mirror. The required power supply for the driver PCB is 5V/12V and its internal HV boost circuit provides the 60V power supply to the HV DAC (AD 5504). The 26-pin connector on its back side is designed for connecting to the Raspberry Pi but it will work with any SPI hardware.
Product Highlights
Small size, high integration degree
Packaging
Our production plant
Product Environmental Compliance Information
Parameters | Specifications | Unit |
operating wavelength | 1525~1565 | nm |
Insertion Loss | ≤1.2 | dB |
Crosstalk | ≥40 | dB |
PDL | ≤0.15 | dB |
WDL | ≤0.3 | dB |
TDL | ≤0.3 | dB |
Return Loss | ≥40 | dB |
Repeatability | ≤0.1 | dB |
Durability | ≥1×109 | cycle |
Switch Time | ≤30 | ms |
Power Supply | 500 | mW |
Switch Mode | Non-latching |
|
Power Supply2 | ≤58 | V |
Power Consumption | ≤2 | mW |
Fiber Type | 9/125 single mode fiber |
|
Fiber Pigtail | 9/125/250um bare fiber |
|
Fiber Length | 1.00±0.05 | m |
Connector | NA |
|
Package Dimension | φ5.5×42 | mm |
Operation Temperature | -5 ~ +65 | ℃ |
Storage Temperature | -40 ~ +85 | ℃ |
Operation Humidity | 5 ~ 95 | %RH |
Storage Humidity | 5 ~ 95 | %RH |